Sony 125x/127x

      >> Introduction
      >> Layout and Setup Tips 
      >> Spacer Mod for Large & Centered Rasters
      >> G2 Voltage Adjustment (White Balance)
      >> Manuals / Downloads

Lifting up the shield over the video output boards exposes the two video output cards. These card do fail, and usually result in no video output from one or more CRTs. These boards to run warm, and corrosion on any or all of the module connectors can result in an intermittent image. The video signal comes in on the RCA jacks going to each board, the control signals come in on the gray ribbon cable on the CA(G) board and then jumper over to the blue board via the connectors.