Zenith PRO 841x/851x

      >> Introduction 
      >> Layout and Setup Tips 
      >> Focus Block Replacement 
      >> CRT Tube Replacement 
      >> Manuals / Downloads 

Mount the new HV divider section to the set frame, insert the 4 HV leads (the order of the red CRT HV leads is not important). Connect the focus modulation wire if applicable, and route and connect the 2 pin connector to the deflection board.

A ‘Z’ shape bracket is included with the new focus block to mount the control section to the one side of the top of the chassis. Use the two longer screws located in a baggie to mount the bracket to the control block. Use the two other supplied hex screws to mount the control section to the chassis.